Wohler AMP2-16V-M, Руководство пользователя

Страница: 87 / 172

Page 80
Cluster Configuration Screen
The Cluster Configuration Screen allows you to define and select clusters for
display on the Main Screen.
Configuration Selection
Menu
Main Screen
Menu
Configure
Monitor Mixer
Monitor Mixer
Configuration Menu
Cluster Configuration Screen
Set Clusters
Figure 5–11: Cluster Configuration Screen
0 0
-60 -60
-50
-40
-30
-10
-20
-10
-20
-30
-40
-50
P
a
i
r
1 P
a
i
r
2 P
a
i
r
3 P
a
i
r
4 P
a
i
r
5 P
a
i
r
6 P
a
i
r
7 P
a
i
r
8
Cluster Configuration Screen
Save / Exit Help Cancel
1 2
Cluster
Start
Edit
Cluster
Label
Cluster
End
Select
Cluster
Default
2
Cluster Configuration Screen
Auto Set
Note:
When you turn off channels in the Monitor Mixer Configuration
Menu, they will appear gray on the Cluster Configuration Screen.
Moreover, they will not appear at all on the Main Screen and the remaining
meters will automatically redistribute themselves to display evenly on the
screen.
1. Cluster Start: Rotating this knob moves the left side of the bracket so you
can select the starting channel of a cluster. You can create up to eight
clusters. Pressing this knob sets the new cluster.
2. Edit Cluster Label: Pressing this knob proceeds to the Label Menu so you
can enter or change the cluster label, shown vertically in
Figure 5–11 as Pair
1. If a partial cluster or multiple clusters are bracketed, then this knob is
disabled.
3. Auto Set: Pressing this control automatically sets the clusters according to
the Channel Functions of each pair. The Channel Function settings are
made in the Monitor Mixer Configuration Menu. After using the Auto Set