WMH Tool Group PERFORMAX 22-44 Plus, Руководство пользователя

Страница: 9 / 25

9
Assembly and Setup
If you purchased the optional Performax 22-44
Plus Stand refer to its assembly instructions
before proceeding with the drum and conveyor
assembly.
1. Attach the handwheel (Fig. 1, Item A) to the
height adjustment screw and tighten with the
4mm Allen wrench supplied.
2. Place the conveyor upside down on a table
surface.
3. Raise the drum by turning the handwheel
(Fig. 2, Item B) clockwise.
4. Align the four holes in the conveyor with the
four holes in the base of the drum assembly.
5. Secure the conveyor in place with four
5/16”-18 x 3/4” socket head cap screws (Fig.
2, Item C), four 5/16” lock washers and four
5/16” flat washers.
6. Plug the motor cord into the control box
receptacle.
Drum Height Control
Drum height is controlled by the height
adjustment handle (Fig. 2, Item B). Turning the
handwheel in a counterclockwise direction
lowers the drum.
Turning the height adjustment handwheel one
revolution lowers the drum approximately 1/16”.
Conveyor Belt Tension
Conveyor belt tension adjustment may be
necessary during the break in period to
compensate for belt stretching.
If the conveyor belt can be stopped by hand
pressure applied directly to the top of the
conveyor bed, the belt is too loose. Insufficient
belt tension will cause slippage of the conveyor
belt on the drive roller during sanding
operations.
Excessive belt tension can result in bent rollers,
bent take-up brackets and premature conveyor
belt wear.
After the PowerFeed unit has been installed,
adjust the hex nuts (Fig. 2, Item D) on both sides
of the conveyor to obtain a tight, and equally
tensioned, conveyor belt. Use the attached
wrenches (Fig. 2, Item E) to adjust the hex nuts.