OPERATING INSTRUCTIONS
*
We recommend that before you install your log set you familiarize yourself with the control valve layout. This will
help you to be confident operating the log set when fully installed (see figures below for typical control positions).
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY,
A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
BEFORE LIGHTING,
smell all around the Outdoor
Campfire area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle on the
floor. IF YOU SMELL GAS FOLLOW THE
INSTRUCTIONS ON PAGE 1.
Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or turn
by hand.
DO NOT
try to repair it. Call a qualified,
professional service technician. Force or attempted repair
may result in fire or explosion.
DO NOT
use this appliance if any part has been
under water. Immediately call a qualified,
professional service technician to inspect the Outdoor
Campfire and to replace any part of the control
system and any gas control that has been under
water.
LIGHTING INSTRUCTIONS
Shutting Off the Campfire
Turn off; rotate the manual gas control knob clockwise to the “OFF” position.
CAUTION:
DO NOT
turn the main gas valve knob to the “ON” position
FOR 45 SECONDS
after shutting the unit off.
STOP – READ SAFETY INFORMATION ABOVE.
1. Push in the manual gas control knob slightly and turn clockwise to the “OFF” position.
2. Wait 5 minutes for gas to clear out.
3. Place a burning match to the surface of the lava granules that cover the burner. Do not hold the match by hand.
4. After the match is burning and in position, push in the manual gas control knob slightly, and slowly turn the knob
counter-clockwise to the “ON” position.
6
