10
CHECK TIRE PRESSURE
The tires on your tractor were over in -
fl ated at the factory for shipping pur pos es.
Correct tire pressure is important for best
cutting performance.
• Reduce tire pressure to PSI shown in
“PRODUCT SPEC I FI CA TIONS” section
of this manual.
CHECK DECK LEVELNESS
For best cutting results, mower hous-
ing should be properly leveled. See “TO
LEVEL MOWER HOUSING” in the Service
and Adjustments section of this manual.
CHECK FOR PROPER POSITION
OF ALL BELTS
See the fi gures that are shown for replac-
ing motion and mower blade drive belts
in the Service and Adjustments sec tion
of this manual. Verify that the belts are
routed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your trac-
tor, check to see that the brake is properly
adjusted. See “TO ADJUST BRAKE” in
the Service and Adjustments section of
this manual.
Defl ector
Shield
Latch
Hooks
Mulcher
Plate
✓
CHECKLIST
Before you operate and enjoy your new
trac tor, we wish to assure that you receive
the best per for mance and sat is fac tion
from this Quality Prod uct.
Please review the following checklist:
✓
All assembly instructions have been
completed.
✓
No remaining loose parts in carton.
✓
Battery is properly prepared and
charged. (Minimum 1 hour at 6 amps).
✓
Seat is adjusted comfortably and tight-
ened securely.
✓
All tires are properly infl ated. (For ship-
ping purposes, the tires were overin-
fl ated at the factory).
✓
Be sure mower deck is properly leveled
side-to-side/front-to-rear for best cutting
results. (Tires must be properly infl ated
for leveling).
✓
Check mower and drive belts. Be sure
they are routed properly around pulleys
and inside all belt keepers.
✓
Check wiring. See that all con nec tions
are still secure and wires are properly
clamped.
While learning how to use your tractor, pay
extra attention to the following important
items:
✓
Engine oil is at proper level.
✓
Fuel tank is fi lled with fresh, clean, regu-
lar unleaded gasoline.
✓
Become familiar with all controls - their
location and function. Operate them
before you start the engine.
✓
Be sure brake system is in safe op er -
at ing condition.
INSTALL MULCHER PLATE
NOTE:
If you installed the mulching blades
you will need to install the mulcher plate.
1. Raise and hold defl ector shield in
up right po si tion.
2. Place front of mulcher plate over front
of mower deck open ing and slide into
place, as shown.
3. Hook front latch into hole on front of
mower deck.
4. Hook rear latch into hole on back of
mower deck.
CAUTION:
Do not remove defl ector
shield from mower.
TO CONVERT TO BAGGING OR
DIS CHARG ING
NOTE:
The mulching blades will dis charge
and bag grass, but for best bagging and
discharging install the high per for mance
blades.
1. Remove mulcher plate and mulching
blades and install high performance
blades, (see BLADE REMOVAL in the
Maintenance section of this man u al).
2. Store mulching blades and mulcher
plate in a safe place. Your mower is
now ready for dis charg ing or in stal -
la tion of optional grass catcher ac-
ces so ry.
For Parts Call K&T 606-678-9623 or 606-561-4983
www.mymowerparts.com
