Note
：
When the switch connected workstations, servers, routers or other ethernet
devices the cable length should be within 100 meters;
The Auto-MDI / MDIX ethernet interface is enabled by default. Category 5,the
standard network cable or crossover cable can be used for Ethernet connection.
Do not connect the RJ45 port to the phone line
3.2 SFP Port connection
ON-PS2024G SFP port only support Gigabit fiber module. Recommended use
of standard SFP module products
The process of installing a fiber module on a switch is as follows:
First, grasp the optic fiber module from the side, insert it smoothly along the SFP
port slot until the optic fiber module and switch are in close contact;
Second, confirm the Rx and Tx ports of the fiber module when connecting, insert
one end of the fiber into the Rx and Tx ports correspondingly, ensure that the Tx
and Rx ends of the interface are connected correctly and the other end of the
fiber is connected to another device;
Third, please check the corresponding indicator light status after power on. If the
light blinking that the link is properly connected, if the light is off , the link is
failure, please check the line to confirm that the corresponding equipment is
enabled.
Note
：
Does not allow excessive bending fiber, the radius of curvature should
not be less than 10cm;
Ensure the cleanliness of the fiber surface;
