52
Originalbetriebsanleitung
FLEXI
MIX
2
FMII_BAoDB_en_1401 • rs
Control module
4.
Adjust the air inlet pressure for the metering pumps up to 3,0-3,5 bar.
5.
When prompted by the control
system, pour a specified quantity
of material via the spray gun
into a measuring cup (generally
1000 cm³) and acknowledge this
step by pressing .
6.
Close and secure the spray gun
again once the filling process is
finished.
7.
Set the air inlet pressure for the
metering pumps right down to
zero.
8.
Wait a few minutes to allow the
entrained air to escape from the
material in the measuring cup
(particularly with more viscous
materials).
9.
Enter the material quantity
poured as the measured volume.
You can enter the measured vol-
ume in cubic centimeters (ccm) or
U.S. fluid ounces (fl.oz.).
Fig. 68: Control system prompt
Fig. 69: Measured volume and K factor
The more accurately you work here, the more precise the mixing ratio will be
later on!
10.
Press the Calculate button to have the new K factor determined by the
control system.
11.
Save the new settings.
You can quit the menu by pressing the Finished button.
5.5.3 Flush parameters
By the definition of flush parameters you can set a flushing program up to eight
sequential steps that are worked through automatically. This feature requires
automatic flushing valves. So it can only be used if the
FLEXI
MIX
2
is equipped
with a standard mixing unit. For
FLEXI
MIX
2
with external mixing unit you must
control the flushing process manually using the flushing ball valves.
The flushing volumes and the se-
quence of steps should be agreed
with the materials supplier and set
accordingly. Certain components
could be incompatible. Changes can
be made later at any time.
Press the button in the Setup menu
shown on the left to open the Flush
parameters input window.
You define the flush parameters step
by step. To do this first enter the vol-
Fig. 70: Flush parameters
ume or duration of the step concerned in seconds or cm³.
Содержание FLEXIMIX 2 HERKULES Series
Страница 2: ......
