µW0001F125U-FIT$0108032600009Ä
W0001F125U-FIT$010803260000
Fitting
Instructions
TOWBAR
For Ford Mondeo Hatch/Saloon
July 2007-
F125U
for
F125A,
F125AQ
F125AQF
MATERIALS
A
1
Cross Bar
B
2
Bracket
D
2
Bolt Straps
E
2
Long Bolt Straps
F
2
M10 x 1.5 pitch Nuts, Lock Washers, Flat Washers (OD 30mm)
G
4
M10 x 1.5 pitch Nuts, Lock Washers, Flat Washers (OD 30mm)
H
6
M12 x 40 x 1.75 pitch Bolts, Nuts, Lock Washers
J
1
Foam Bumper Support Strip
K
1
Flip-Up Electrical Plate
M
1
Electrical Plate Bracket
ZQ
1
Tow Ball Neck ZF3022 or ZQ3022 or ZQF3022
FITTING
1. Remove bumper. (3 screws in wheel arch, 2 screws on top edge, 2 plastic screws on bottom edge, pull tips away from
body clips.).
2. Remove steel bumper beam to expose openings into chassis rails.
3. Lower the rearmost exhaust silencer and remove the exhaust heat shield.
4. Insert Brackets (B) into chassis rails and loosely secure with Bolt Straps (D) and fasteners (G)
Note: Use holes shown
for Hatchback (5 door) vehicles and holes (G1) for Saloon (4 door) vehicles.
5. Assemble Long Bolt Straps (E) through Brackets (B) and secure using fasteners (F).
Note: Use holes shown for
Hatchback (5 door) vehicles and holes (F1) for Saloon (4 door) vehicles.
6. Assemble Crossbar (A) to Brackets (B) using fasteners (H).
7. Assemble the chosen Tow Ball Neck variant and Bracket (M) to Cross Bar (A) using separate fitting instructions.
8. Assemble Flip-Up Electrical Plate (K) to Bracket (M) using separate instructions. Tighten as appropriate to allow rotation
of the Electrical Plate Bracket up into the bumper when not towing.
9.
Fully Tighten all Fasteners
10. Refit the exhaust heat shield and silencer.
Note:
Item (J) is not required for Hatch and Saloon vehicles.
Note:
This towbar must be used with either a Witter Towball (part number ZF3022 or ZQF3022 or ZQ3022) or Class A50-1 or
A50-X towball Dimensionally Conforming to A50-1 with a ‘D’ and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which
must be observed
.
Recommended torque settings:
M8 - 27Nm,
M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
Grade 10.9:
M12 – 139Nm, M10 – 78Nm
