Assembly
premo
en-18
4022-D045530
Revision: 02
Pinning the mounted and aligned servo actuator (optional)
There are bore holes (B) on the housing for pinning the servo actuator to the machine.
5.3
Components mounted on the output side
The prescribed screw sizes and tightening torques for the output flange can be found in
Chapter 9.2 "Specifications for mounting on the output side", Table "Tbl-14".
Drill pin holes into the machine base according
to the bores (B) of the housing.
Ream the bores to the corresponding fit size for
the cylinder pins.
For specifications on the cylinder pins, refer
to Table "Tbl-6".
Fixate the servo actuator with the cylinder pins.
Pin holes in gear housing
Size
Quantity x cylinder pin with
interior thread
DIN 7979
DIN EN ISO 8735 Form A
Size 1
–
Size 2
2 x 6 m6
Size 3
2 x 8 m6
Tbl-6: Pin holes
Distortions during assembly can damage the servo actuator.
Mount gearwheels and toothed belt pulleys onto the output shaft / output
flange without forcing.
Never attempt to assemble by force or hammering!
Only use suitable tools and devices for assembly.
B
