8
NOTE:
Do not attempt to remove the white molded plastic guide “shell” itself. These pieces are permanently installed into the
drum halves at the factory and are not meant for removal or replacement.
a.
Remove inner drum if not already removed.
b.
Remove sheet metal screws from each rubber strip.
c.
Clean off the residue of the old rubber strip.
1)
ONE STRIP AT A TIME, lay each old strip over each corresponding new strip,
and cut the ends to duplicate the trim angle of the old strip.
2)
After trimming, drill through the existing holds of the old strip to make new holes
in the corresponding new strip.
NOTE:
When trimming or drilling new liner strips, it is important to keep the new and old pieces together TEXTURED SIDES
DOWN, and always drill or cut into a secure wooden surface such as a workbench, or 2” x 4”.
d.
Install the new strips into the existing holes in the tracks in the while molded guide “shell”
with the new screws that are provided.
3.
Relining White Molded Outer Drum Guides - Top Half
The Replacement Kit for the 50G Superwash Outer Drum contains 5 strips (four of equal length
and one short piece) of textured rubber that are mounted in the top half, and the sheet metal screw
necessary for mounting. The 50G Jr. has four strips.
a.
Cut, trim, and drill the top strips in the same manner as the bottom strips.
b.
Taper the ends of the new strips that line up to the entry and exit chutes to match the
taper of the old ones.
c.
Install the new strips into the existing holes of the liners as described above.
C.
Electrical System
WARNING
:
ALWAYS DISCONNECT THE MACHINE FROM POWER SOURCE WHEN
WORKING WITH THE ELECTRICAL SYSTEM.
1.
Replacing Heater Coil.
a.
Remove cover plate from starter switch.
b.
Remove old heater cover.
c.
Insert new heater coil.
d.
Replace cover plate over starter switch.
2.
Replacing Heater Coil and Starter Switch Unit.
WARNING
: INCORRECT WIRING CONNECTIONS CAN CAUSE PERSONAL INJURY
OR DAMAGE TO MACHINE.
a.
Remove cover plate from NEW starter switch.
b.
Install NEW heater coil into NEW starter switch.
c.
Remove cover plate from old starter switch.
d.
Disconnect all wires from terminals.
e.
Loosen the wire retainer screw. Remove the lock nut that attaches starter switch box
to motor cover.
f.
Knock out one of the openings in the NEW starter switch box and mount to the motor
with the conduit nipple and lock nut.
g.
Reconnect all wires.
h.
Install the cover plate.
