Withings ScanWatch Series, Инструкция по установке и эксплуатации

Страница: 86 / 104

EN - 86
ScanWatch
v1.0 | August, 2020
Cleaning and maintenance
Cleaning my watch
1. Use a lint-free cloth moistened with warm water to clean the glass and
casing of your ScanWatch.
2. Run the fluoroelastomer wristband under warm water and rub it with
hypoallergenic soap to clean it.
3. Dry the fluoroelastomer wristband with a soft cloth.
Notes
:
• If the side button of your ScanWatch appears to be stuck, we advise you to
rinse the casing of your watch with clear, warm water and dry it using a lint-
free cloth.
• If the altimeter opening of ScanWatch becomes dirty or clogged with debris
and sweat, it can prevent the watch from accurately measuring elevation. If
this occurs, please clean the case of ScanWatch with warm, soapy water and
then allow it to dry. The watch should also be cleaned anytime that you work
out with it on.
Cleaning my wristband
Leather wristbands
• Wipe down the band with a lint-free cloth. You can lightly dampen the cloth
with water.
• Leather wristbands are not water-resistant.
• Leather wristbands should not be worn during workouts.
• Light-colored leather wristbands: avoid direct contact with dark-colored
clothing as color transfer may occur.
• Sunlight, humidity, cosmetic products, and abrasive chemicals (such as
cleaning agents or insect repellent) can damage your wristband
.
Silicone wristbands
• Rinse the band with warm water and rub it with mild soap.
• Wipe down the band with a lint-free cloth before you put your band back on.
• Light-colored silicone wristband: avoid direct contact with dark-colored
clothing as color transfer may occur.
Milanese and metal wristbands
• Wipe down the band with a lint-free cloth. You can lightly dampen the cloth
with water.
• Milanese and metal wristbands are not water-resistant: soaking them might
cause damages.
• Milanese and metal wristbands should not be worn during workouts.