www.witeg.de
12
2.2 Instructions
For a safety and faultless using of the device it is indispensable that you read the following
instructions purposely and follow them by the use.
Connect the device only to the suitable power supply. Please have a look to the
identification plate.
Due to its functions the Heating Mantle is not protected against incoming water. Only a
professional handling can avoid hazardous accidents.
Only persons with sufficient safety knowledge are allowed to use this device.
Use the device only in electric circuits with ground fault circuit interrupter.
Do not touch the device if any liquid is flowed into the device (e.g. broken glass vessel)
and firstly switch the power supply off. After that please pull out the power plug.
Check the power supply cord before you stick it into the electrical outlet.
Do not use power bars to extend the power supply cord.
Only use extension cables with sufficient cable cross section.
Do not touch the device with wet hands during the usage because this might cause an
electrical shock.
If unexpected sound, smell or smog is generated by the device, pull out the main plug
and contact the manufacturer or your supplier immediately.
Disconnect the power supply plug before cleaning or maintenance.
If you use radiation or contaminated samples the responsibility is only up to you.
Do not put heat-sensitive items at the device.
Only use adequate sized vessels and avoid an over boil of the liquids.
Do not clean the scorching device.
Use this device only if you read the whole safety instructions.
This device should only used by persons who are familiarized with safety instructions
made for laboratories.
Pay attention that no liquid reaches the controller or inward of the capsule.
You have to keep the device clean if you want to get a longer life of it.
Wear corresponding protective work clothing during the usage.
Pull out the power cable if you didn’t want to use the device for a longer time.
Please make sure that you use only vessels with heat resistance glass (look at 3.4).
Do not heat up the heating mantle without any vessel to avoid an overheating.
Do not heat the up the device more than it is necessary - for lower energy consumption
and your own safety.
witeg Labortechnik GmbH, WiseTherm
®
WHM Heating Mantle with Controller
