WISYCOM s.r.l. - Via Spin, 156 - I-36060 Romano d’Ezzelino (VI) - Italy - MTP30-eng-U02.doc
Tel. (Ph.). +39 0424 382605 - Fax +39 0424 382733 - http:// www.wisycom.com - e-mail: [email protected]
1.3 POWERING
UP
Move the wireless power switch (3) in “I” position to activate wireless transmission: a green
LED lights up (blinking when battery is low! See 1.1)
1.4 SETUP CONTROLS
Open transmitter Body to access the
“display and controls” area (fig. 3):
A) Graphics Display (
OLED
)
B) Channel selection button (
ch
)
C) MIC gain setup button (
gain
)
D) 3 position
selector
(
-
/
click
/ +)
Fig. 3
1.4.1 LED POWER UP (DISPAY IS IN OFF CONDITION)
Pushing down selector (
click
), oled turns on. A first menu with serial NO and brand logo is
displayed, then <status> menu enters automatically.
Pushing and holding selector (
click
) > 2 sec, serial NO menu is displayed till (
-/+)
is selected.
1.4.2 DISPLAY POWER DOWN (DISPLAY IS IN ON CONDITION)
Pushing and holding selector (
click
) > 2 sec, display is turned off.
Display turns off automatically after 15 sec, unless in <irda> menu or in <audio> menu (with
audio level < 5% from nominal).
1.4.3 DISPLAY
MENU
Setup menu are accessed in sequence:
<status>
<tuning>
<audio>
<mic>
<rf power>
<other>
<irda>
<lock>
Using <
+/-
> selector all menus can be accessed in sequence, push <click> to enter edit
mode:
<
+/-
> to setup field
<click> again to confirm changes and exit.
exit without confirmation
if no button is pressed after a few seconds time out.
1.4.3.1
<start up> menu
This menu is displayed during power up for few seconds:
Keep selector pushed to hold this menu
. Main information are:
Product name – software version
Brand name
Transmitter bandwith
Serial No:
1.4.3.2
<status> menu
This is the first menu displayed after power up.
Major info are displayed:
- Current channel/group (i.e. CH:00 GR:1)
- Current frequency (i.e. 770.000 MHz)
- Mic gain (i.e. -04) and high pass filter (i.e. FLAT)
- RF active, top right label RF (if present RF is on)
1.4.3.3
<tuning> menu
This menu can be entered by scrolling selector or using
quick
channel setup
buttons (<
ch
>).
In this menu current channel/group and frequencies can be setup.
Use the selector to change values (<
+/-
>) and <
click
> to confirm.
Sync
group is a quick self settable channel synchronized by receiver.
C
D
B
A
+
-
CLICK
+
-
CLICK
