WISYCOM s.r.l. - Via Spin, 156 - I-36060 Romano d’Ezzelino (VI) - Italy - MTH300-eng-u03.doc
Tel. (Ph.). +39 0424 382605 - Fax +39 0424 382733 - http:// www.wisycom.com - e-mail: [email protected]
1.4.3.2
<tuning> menu
This menu can be entered by scrolling selector or using
quick channel setup
buttons (
ch+
and
ch-
).
In this menu current channel/group and frequencies can
be setup.
Sync
group is a quick self settable channel
synchronized from receiver.
1.4.3.3
<audio> menu
This menu can be entered by scrolling selector or using
quick gain setup buttons (
gain+
and
gain-
).
To help proper audio gain setting, an audio bar is
supplied (with peak hold bar)
TRY TO SETUP TO
HAVE A MAX PEAK HOLD BAR CLOSE TO 100
.
High pass audio filter can be setup with different preset
values.
NOTE: while in this menu display is not automatically
turned off
.
1.4.3.4
<rf power> menu
This menu can be entered by scrolling selector.
RF power can be setup to High (50 mW ERP) or Low (10
mW ERP).
1.4.3.5
<others> menu
This menu can be entered by scrolling selector.
Power switch green LED brightness can be setup
LED
light. Modulation peak LED on power switch (become
RED when audio get close to saturation) can be
enabled/disabled). Battery type can be setup in Alkaline
or NiMH.
1.4.3.6
<irda> menu
This menu can be entered by scrolling selector.
While is this menu MIC can be connected to IRDA for
setup or firmware upgrades.
NOTE: while in this menu display is not automatically
turned off.
1.4.3.7
<lock> menu
This menu can be entered by scrolling selector.
Long pressing (2 sec.) selector button (
click
) it locks
MTH300 in transmission mode.
To unlock, long pressing (2 sec.) selector button again.