Wisycom Srl - Via Spin, 156 - I-36060 Romano d’Ezzelino (VI) - Italy
tel. +39 0424 382605 fax. +39 0424 382733 http:// www.wisycom.com - e-mail: [email protected]
Subject to change without notice
BOOSTER MODULE SETUP
2 digits LED display with booster
gain indication [dB].
Brightness can be adjusted through the user menu.
Signaling LED, multicolor:
white
: when turning-on indicates the booster start up
yellow
: booster bypassed, antenna becomes passive
green
: active booster with gain between 1 ÷ 8 dB
blue
: active booster with gain between 9 ÷ Max Gain
red
: fast blinking, powering insufficient (lower than ≈ 9,5Vdc)
+ / - , adjusting buttons
MENU/SAVE, selection button allows to edit the following parameters (after 5 second
gain indication is restored by default).
BOOSTER GAIN SETUP
, from normal indication:
Push MENU/SAVE to enter gain edit mode,
Then edit the gain with + / - ,
Push again MENU/SAVE for confirm or wait 5 sec to return without saving.
It is possible to setup the gain between 1 ÷ 15/16 dB in steps of 1dB. Decreasing
gain to the lowest value, “
bP
” is displayed: booster is bypassed and antenna
operates in a passive way. Confirm the new setup value within 5 sec by pressing
one more time on the MENU/SAVE button. Without any confirmation within 5 sec.
the modification is cancelled.
DISPLAY BRIGHTNESS
(first digit “d”, second digit value from 0 to 8)
Push
twice
MENU/SAVE to enter brightness edit mode,
Then setup your desired brightness with + / - ,
Push again MENU/SAVE for confirm or wait 5 sec to return without saving.
PASS THROUGH SETUP
Push
3 times
MENU/SAVE to enter brightness edit mode,
Then setup your pass through with + / - :
“
b0
” is no 12V pass through
“
b1
” is 12V pass through Enabled.
Push again MENU/SAVE for confirm or wait 5 sec to return without saving.
ON/ALARM BLINK IN RED TO INDICATE LOW VOLTAGE
ERROR
FEEDING VOLTAGE UNDER 10V:
-
CHECK YOUR FEEDING CABLE
-
CHECK YOUR ANTENNA (TAKE OUT THE INPUT CONNECTOR AND CHECK)
-
CHECK YOUR FEEDING DEVICE (SPLITTER, RECEIVER) TO BE ABLE TO
SUPPLY ENOUGH CURRENT (100mV @ 12V)
1
4
2
3
1
2
3
4