RS 005 Instruction
02
Caution:
If installed in the backside of the load bar, switch to the Front/Back side by connecting 1
and 2 position (use the supplied connector).
If installed at downside of the load bar, switch to the Underside side by connecting 2 and 3 position (use the supplied
connector) .
4
Inserting the batteries
）
11
.
03
.
03
.
SMS
-
RS005YT-02-V2
Instruction
RS 005
c.The LED will flash to confirm
the correct battery insert.
1 Press Up and Down button simultaneously
once, press stop button 8 times, the motor
will vibrate once.
）
the motion sensor could control
the motor.
3
）
Then, the learning is successful,
1
2
）
Short press the learning button on motion sensor
once within 10s, the indicator light will be on and off
once, the motor will vibrate once.
1
1
Code learning
5
Remarks: Use a emitter which has already been programmed in the memory of the motor.
1
8
1
Activate the motion sensor
6
Long press
for 5s
1
1
1
)
on the back side for 5s, the motor
will vibrate once.
Long press the learning button
2
)
Press Up button once.
3
)
will vibrate once. The motion sensor is
activated successfully.
Press Stop button to exit, the motor
1
There are 10 thresholds from 0-9 totally in the potentiometer (F). Using the supplied flat screwdriver adjust to different
levels and choose a suitable threshold.
1 = high sensitivity to shaking; very small shaking can close the awning.
9= low sensitivity to shaking; very strong shaking can close the awning.
0 threshold: Personalized threshold
Threshold adjustment
7
a.Remove the inner cover using
the supplied flat screwdriver.
b.Insert 2*AAA Alkaline batteries
following the polarity indication.
1) Pre-defined threshold adjustment
1.Adjust the threshold potentiometer with the
supplied flat screwdriver to appropriate value.
1= high sensitivity to shaking
9 = low sensitivity to shaking
2.Slide
the
motion
sensor ’s upper cover
to bottom cover till the end stop.
3.After
the
installation
and
the
awning
get
still
,
the
pre
-
defined
threshold
mode
set
is
finished
.
4.Check the setting and modify it in the
event of incorrect sensitivity to
shaking.
2) Personalized Threshold Adjustment
1.Switch the threshold potentiometer to 0.
2.Slide the motion sensor’s upper cover to the bottom cover
till the end stop.After the installation and the awning get still,
it is in the personalized threshold mode.
6
7
8
3
4
5
0
1
2
9
6
7
8
3
4
5
0
1
2
9
remove the cover
fix with screws
remove the cover
3.Shake the awning manually to simulate the maximum level of
wind vibration allowed till the awing close automatically. Then
the motion sensor is set.
a.If the awning close satisfactorily, it means the motion sensor
is set correctly.
b.If the awning does not close satisfactorily, stop the awning by
pressing the Stop button on the remote control and go to the
next step “personalized threshold setting change”.
4.Personalized threshold setting change.
a.Use a remote control to open the awning.
b.Remove the upper cover from bottom and wait for 5s.
c.Slide the upper cover to the bottom cover and follow the
operation in step 3,4.
