
WBD500
User Guide
I. Product Overview
1. Power Input
2. Laser LEDs Button
3. Power/Mode Button
4. Sensitivity Wheel
5. Extendable Antenna
II. What’s in the Box
1× Anti-Spy Detector
1× AC110-240V to DC 5V Charger
III. Radio Frequency Detection
3.1. Power on the detector by pressing the Power Button once. The blue indicator light will
be on and the battery life icon will be seen too.
3.2. The beep mode icon will show up on the LCD screen. That means the device has
entered into beep mode automatically.
3.3. Press the Mode Button once to switch to vibration mode and the vibration mode icon will
appear on the LCD screen.
3.4. Push up the sensitivity wheel and extend the antenna to the longest to widen the search
scope.
3.5. If RF signals are detected, the detector will start vibrating or beeping, and the red indicator
light will flash fast.
3.6. Gradually push back the sensitivity wheel and shorten the antenna to narrow down
to the source of the radio signal.
3.7. The closer you are to the hidden bug, the louder or stronger the beeping or vibration
will be. The signal icon will show you how strong the surrounding RF signals are.
3.8. Power off the detector by pressing the Power Button for 3 seconds. The blue indicator
light will be off.
IV. Camera Lens Detection
4.1. Power on the detector by pressing the Power Button once. The blue indicator light will be on.
4.2. Press the Laser LED Button once to turn on the Laser LEDs and they will keep flashing.
4.3. Press and hold the Laser LED Button. The longer you hold it, the faster these Laser LEDs
will flash. If you keep holding it long enough, laser LEDs will be back to flash at the initial speed.
4.4. Look through the lens and you will find a blinking red dot where the camera lens locates at.
4.5. Press the Laser LED Button once again to turn off all the Laser LEDs.
4.6. Power off the detector by pressing the Power Button for 3 seconds. The blue indicator
light will be off.
V. Charging
5.1. Power off the detector and connect it to an outlet AC power supply using the included
DC5V charger.
5.2. It will take 2 hours to obtain a full charge.
5.3. When the detector is fully charged, a full battery icon will show up on the LCD display.
6. Camera Detection Lens
7. Blue Indicator Light
8. Red Indicator Light
9. LCD Display
10. Laser LED