Wisenet TNO-6322ER, Руководство пользователя

Страница: 8 / 21

overview
8_
overview
INSTALLATION
Precautions before installation
Ensure you read out the following instructions before installing the camera:
~
Install the system based on the following directions. If you want to install using a different method, you
should confirm the safety recommendations by making a request to the manufacturer in advance.
~ The gross weight of the system is 10.5 kg. Be careful when lifting the system, and put on proper anti-slip
gloves.
~
It must be installed on the area (ceiling or wall) that can withstand 4 times the weight of the camera
including the installation bracket.
~ Stuck-in or peeled-off cables can cause damage to the product or a fire.
~
For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
How to install seal fitting in the cable entry
1. Install the conduit seal system according to the IEC/EN60079-14
standard.
2. Check items that are installed together with screws, conduit sealing
parts, etc.
3. After connecting screws to the cable entry, tightly connect the seal
fitting with an explosion-proof nipple.
4. Pass cables that are connected to the outside through the seal fitting.
Conduit sealing parts should obtain IECEx/ATEX certification.
J
`
To install this device, install the Ex Equipment Cable Grands or Ex Components according to IEC 60079-14 / EN 60079-14.
The main cable should be connected to a junction box or indirect input terminal box at a distance of at least 3m in length.
Installing Sunshield
Assembling the Sunshield on the base housing with 2 x screw bolt.
Installing Wall Bracket
1. Use wall mount bracket that can bear at least 4 times the weight of the unit.
2. Secure the unit to the wall mount bracket (secure the vertical place) using 5-M8 screws and washers
3. Apply a generous amount of thread locking compound (Loctite 270 (not included))
Screws (M8)5x
(Flat washer & Spring washer(M8))
Wall Bracket