7
Explore Screen Configuration
The recorder screen consists of the following.
■
The screen may be configured differently depending on the menu selected by the user.
No.
Screen configuration
Detailed description of function
Menu
Clicking on each menu takes you to the corresponding menu screen.
Select list of device/event
Select to view list of cameras or events.
Device List
Click
List
to display list of registered cameras in the recorder.
You can also register the camera manually or automatically.
Event List
Click
Event
to display list of events.
Layout List
This displays a list of the default layouts and the layouts that have been created.
You can set and play sequence on the list of layouts.
PTZ Control
Controls the connected PTZ camera.
Function buttons
Function that is frequently or urgently used.
(export, alarm stop, manual recording, OSD display, channel information, check camera status, auto-switch screen,
split mode setting, change aspect ratio, switch to full screen mode)
Video window
Shows the video of the camera connected to the recorder.
Display system status and
additional functions
●
Displays the status of the system, hard disk, and network.
●
The ID of the connected user is displayed.
●
Displays a QR code to download User Manual.
Display events and
functions to control videos
Displays events that occurred on the device and functions related to video control.
Record Setup
You can set resolution, IPS, and quality of recordings by channel, and by recording type of standard / event.
You can check frame rates and data transfer amount of Full Frame and Key Frame recordings for each channel, and
set the transfer limit for recordings.
Setup > Record > Record setup
●
Apply to CH : If you select <
Apply to CH
>, “
Apply to CH
” confirmation window will appear. After selecting
channels that the settings will be applied to, click on <
OK
> to apply them to the selected channels.
●
: The camera of the corresponding channel is displayed on the list or as a thumbnail.
●
Camera name : Displays the camera name.
●
IP Address : Displays the camera IP address.
●
Normal recording, Event : Configures Standard recording and Event recording.
– FULL : Records all frames fed by the camera.
– I-frame : Records only key frames fed by the camera. Depends on camera settings.
– OFF : No recording is made.
●
Frame
– FULL : Shows the amount of data for all the scene recordings.
– I-frame : Shows the amount of data for the main scene recordings.
●
Limit : Set the amount of data allowed for input for each channel.
●
Event : When an event occurs, you can set which point you will start or stop recording.
– Pre : When an event occurs, recording will be started regardless of the time set. If you set it to five seconds,
recording will start at five seconds before an event occurs.
– Post : When an event occurs, recording will continue after the time set. If you set it to five seconds, recording will
continue for a further five seconds after an event is finished.
●
Audio : Specify whether to record the sound received from the camera or not.
■
If a channel's data transfer exceeds defined allowed limit, then it may affect to other channels, and may force switching to <
I-frame>
recording
even when the channel is configured to <
FULL
> recording mode. For Key Frame recording channels, the icon for limited recording appears
on the live screen's top side. But if the sum of the limits is below the max limit, you can still receive the entire frames despite exceeding the
permitted bitrates for each channel.
■
A channel displayed in yellow indicates that the recorded data is not being transferred from the camera and that the recording is being performed
temporarily using another profile on the camera. Check the channel information to see the applied profile to the channel listed in yellow. A
channel displayed in orange indicates that the amount of inputted data is greater than the permitted data amount. In this case, it is impossible to
record all of the incoming frames.
Instead, only part of the frames (1 or 2 frames per second) can be recorded.
To resolve this issue, you must set the permitted data amount to be greater than the amount of inputted data.
