overview
10_
overview
AT A GLANCE
Front of the main unit
a
b
Item
Description
a
Power indicators
POWER
ON : While the power is on
OFF : If the power is off
b
Status Indicators for Lens
Module
The LED turns on when each channel video is successfully displayed.
Side of the main unit
a
b
c
e f
d
g
h
Item
Description
a
Connection terminal of lens
module
This terminal is connected to the lens module through the cable to connect the lens
module.
b
HDMI port
By connecting an HDMI cable, you can watch a live feed on the monitor.
c
Audio terminal
AUDIO IN
Used to connect to a microphone.
AUDIO OUT
Used to connect to speakers.
d
Alarm I/O Port
ALARM IN
Used to connect alarm input signals. Up to two ports can be used.
Refer to “Alarm In Wiring Diagram” (page 18).
ALARM OUT
Used to connect alarm output signals. Up to two ports can be used.
Refer to “Alarm Out Wiring Diagram” (page 19).
GND
Ground terminal.
e
Power supply terminal
Terminal used to connect to the DC12V power adaptor.
f
PoE+ port
A port that connects to the PoE injector and network cable for power and network connection.
g
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that DHCP can be
enabled. If there is no DHCP server in the network, you must run the Device Manager
program to change the basic network settings such as IP address, Subnet mask,
Gateway, etc., before you can connect to the network.
h
Micro SD Card slot
Compartment for the Micro SD card.
Содержание PNM-9000QB
Страница 1: ...NETWORK CAMERA User Manual PNM 9000QB SLA T1080FA SLA T2480A T2480VA T4680A T4680VA ...
Страница 29: ......