WISE STAR USA CS7230V, Инструкция по установке и эксплуатации, Страница: 10 / 30

10
Operation Function
Call + n + Enter To call the number N preset position
n + Enter To set the number N preset position
n + Off Delete the number N preset position
Cam + n + Enter Set the dome address “n”
Shot + n + Enter N=1
：
Auto the cruise track
Shot + n + Off N=1
：
Stop the cruise tracks
Auto + On Set the start position of auto pan
Auto + Off Set the end position of auto pan
Auto + Enter
The camera will move from the auto pan start position to the
auto pan end position
Wide ZOOM wide
Tele ZOOM tele
Far FOCUS far
Near FOCUS near
Open IRIS open
Close IRIS close
(1) Title Display Function
No.64 preset position can turn on or turn off the display function (including self-check information display) of some certain
cameras. If the No.64 preset position is a normal one, the camera does not have the display function (including
self-check information display).
(2) When camera performs cruise function, the tolerant state is as follows:
To scan point by point automatically from No. 1 preset position to No. 16 preset position. The cruise will not scan those
positions where certain positions are un-preset or deleted after preset, and resort time for each preset position is
3
seconds;
(3) When camera performs scan function, the tolerant state is as follows:
The camera will scan automatically between two designated positions, namely “starting point” (left) and “end point” (right).
The resort time at “starting point” and “end point” is 3 seconds; s tates of dome camera are shown below. The dome
camera will stop scan and implement new action when receiving qualified command.
Note:
The dome camera may result in accumulative deviation in parameters after serving a long period. The starting
point and end point of scan shall be reset.
(4) The item marked with * means the camera have this function, otherwise it will show “NO FUNCTION”
。
5. Special Function—Power-off Protection
When the camera is under scan or cruise track, and power off occurs, the camera will save the state before the power-off.
When power is resupplied, the camera will continue to perform the scan or cruise track automatically under the same
state before power-off. Should scan or cruise track are not performed before power-off, the camera will stop at the first
preset position automatically.
3.ID SETTING
ID of this speed dome can be set by the switch with 10 codes.
Below is the detail of setting ID code: