SAGE P20m
WISDOMAUDIO.COM
7
cables and attach somewhat loosely using a dry-wall screw (or similar),
so you can adjust the bracket for plumb.
3.
Using a bubble level to ensure that the mounting bracket is plumb, mark
screw holes for EZ-Toggle screws in end clips, using the bracket itself as
your template. You can use any opposing (diagonal) set of holes for
mounting of the two EZ-Toggle screws in each end clip.
4.
Rotate the bracket out of the way and install two of the supplied EZ-Toggle
screws in each mounting bracket end clip as follows:
a.
Using a #2 Phillips bit in your cordless drill, spin the E-Z Toggle Anchor
into the drywall until the head of the anchor is seated flush and the
arrows on the head of the anchor point up and down. Repeat this
process for each anchor location.
b.
To “set” the clamp behind the drywall, place the mounting screw into
the anchor and push or tap firmly until approximately 1" (2.5 cm) of
screw is protruding (do not rotate). Then remove the screw. Repeat for
each anchor location.
c.
Rotate the mounting bracket back over the E-Z Toggles, insert the screw
and continue to turn until fastened tightly. The screw stops when the
toggle bar secures itself against the opposite side of the drywall (
inside
the wall). Repeat for each anchor location.
5.
Install screws suitable for the specific wall material (e.g., sheetrock, brick,
concrete, etc.) in all the remaining holes in the mounting bracket to ensure
secure attachment to wall and avoid any resonance from mounting bracket.
Snug down the center screw as well.
6.
Using assistance, while holding the speaker away from the wall, connect
both high- and low-pass speaker cables to the rear mounted connectors. Pay
close attention to connect the correct wires (high- and low-pass) to their
respective speaker connectors while attending to proper polarity.
7.
Fix the speaker into the mounting bracket end clips and press down until
you hear the speaker lock into the mounting bracket clips. When properly in
place, it will snap into position and remain held quite firmly.
8.
Install the security set screw in the end cap, snugging down to the mounting
clip with the supplied Allen driver. This setscrew prevents the speaker from
coming loose by eliminating the vertical movement required to free the
speaker from the bracket.
If you need to remove the speaker from the bracket for any reason, first remove the
security screw using the supplied Allen wrench. A sharp upward rap with the base
