Wisdom Sage Cinema Point 2, Руководство пользователя

Страница: 13 / 20

13
Alternatively, the loop resistance can be easily measured with an inexpensive
volt-ohm meter. Simply twist the two conductors at one end of the cable togeth-
er, and then measure the DC resistance across the two conductors at the other
end of the speaker wire. Doing this measures the total resistance going down
one side and back the other, hence the term “loop resistance.” If this figure is
at or below 0.07 ohms, you are in good shape. When in doubt, more copper
never hurts.
For the purposes of this manual, we will assume that you have already con-
nected the SC-1 System Controller as per the instructions found in its manual.
As such, you should have signal coming from your source component(s) to a
preamp/processor, and then on to the SC-1; following the SC-1, the signal is split
into low and high sections, with the low section going to one or more Wisdom
Audio SA-series amplifiers, and the high section going to additional SA-series
amplifiers, which will drive the planar magnetic panels.
Connect the outputs of your Wisdom Audio SA-series amplifier to the appropri-
ate woofer sections, taking care to get both the channel assignments and the
polarity correct. Connect the positive (+) terminal on the woofer amplifier to the
positive (+) terminal for the Low Pass on the loudspeaker; likewise, connect the
negative (–) terminal on the woofer amplifier to the Low Pass terminal on the
loudspeaker, respectively.
Next connect the outputs of your amplifier for the midrange/treble to the Sage
Cinema Point 2 planar sections using the High Pass connectors in a similar fash-
ion, taking care with both channel assignments and polarity.