2
WPS-100-BUL-A-SL Installation Manual
© 2012 Wirepath Surveillance
WARRANTY
5-Year Limited Warranty
This camera has a 5-Year Limited Warranty. The warranty includes parts and labor repairs on all components found to be defective
in material or workmanship under normal conditions of use. This warranty shall not apply to products which have been abused,
modified, disassembled or improperly installed. Products to be repaired under this warranty must be returned to Wirepath™
Surveillance or a designated service center with prior notification and an assigned return authorization number (RA).
INSTALLATION INSTRUCTIONS
Recommended cabling includes solid copper RG59
or RG6 for video and 18 AWG two-conductor for power.
TROUBLESHOOTING
If you have trouble operating the camera, first refer to the
following guidelines. If the problem persists, contact Technical
Support at 866.838.5052.
Nothing appears on the display
• Check if the power for camera and monitor is ON.
• Check if the VIDEO cable is connected to the camera
BNC video output jack.
• Check if the VIDEO cable is connected to the monitor
VIDEO input jack.
Image appears dim on the display
• Check the monitor contrast setting.
• Check the monitor brightness setting.
• Check the lens. If necessary, wipe with a soft,
clean cloth.
• Check if the camera is facing towards a bright light.
If so, change the camera position.
• If a device exists between the camera and screen,
confirm the signal accepted by the screen is strong
enough – 75 Ohm.
Image appears blurry on the display
• Check the lens. If necessary, clean with a soft,
clean cloth.
The camera is not working properly and the camera
housing is hot
• Check if camera is connected to the correct power
source.
1. Position the camera
mount at the desired
location and use the
provided screws to
attach the camera
base to the wall.
2. Using the DC plug
supplied, connect the
power supply jack to
12VDC and the BNC
Video Output to the
desired video line.
3. Attach the camera
to the mount. Once
the camera is installed,
check the viewing
angle.
4. Install the sun shade
to block direct sunlight
on the
lens.
DIMENSIONS
2.67”
2.67”
3.94”
6.25”
4.84”
2.56”
90˚
5”
12VDC Power
BNC Video
Output
DC Plug
120111
