2
WPS-300-DOM-A Installation Manual
© 2012 Wirepath Surveillance
INSTALLATION INSTRUCTIONS
This camera is intended for indoor use only. Recommended
cabling includes solid copper RG59 or RG6 for video and 18
AWG two-conductor for power.
12VDC Power
DC Plug
BNC Video
Output
TROUBLESHOOTING
If you have trouble operating the camera, first refer to the
following guidelines. If the problem persists, contact Technical
Support at 866.838.5052.
Nothing appears on the display
• Check if the power for camera and monitor is ON.
• Check if the VIDEO cable is connected to the camera
BNC video output jack.
• Check if the VIDEO cable is connected to the monitor
VIDEO input jack.
Image appears dim on the display
• Check the monitor contrast setting.
• Check the monitor brightness setting.
• Check the lens. If necessary, clean with a soft,
clean cloth.
• Check if the camera is facing towards a bright light.
If so, change the camera position.
• If a device exists between the camera and screen,
confirm the signal accepted by the screen is strong
enough – 75 Ohm.
Image appears blurry on the display
• Check the focus of the lens.
• Check the lens. If necessary, clean with a soft,
clean cloth.
The camera is not working properly and the camera
housing is hot
• Check if camera is connected to the correct power
source.
DIMENSIONS
WARRANTY
5-Year Limited Warranty
This camera has a 5-Year Limited Warranty. The warranty includes
parts and labor repairs on all components found to be defective
in material or workmanship under normal conditions of use. This
warranty shall not apply to products which have been abused,
modified, disassembled or improperly installed. Products to be
repaired under this warranty must be returned to Wirepath™
Surveillance or a designated service center with prior notification
and an assigned return authorization number (RA).
4.65”
3.07”
SIDE VIEW
TOP VIEW
BOTTOM VIEW
1. Open the camera
by aligning the two
tic marks and gently
removing the dome
from the base.
2. Using the supplied
DC plug, connect
the power supply
jack to 12 VDC and
the BNC Video
Output to the desired
video line.
3. Position the camera’s
base in the desired
location. Point the
tic mark on the base
in the direction that
the camera will
ultimately face. Use
the provided screws
to attach the
camera base to the
wall or ceiling.
4. To adjust the zoom
and focus, use a
small screwdriver to
loosen (but not
remove) the set
screws. Using the
set screws, rotate the
lens until you achieve
the desired setting.
5. Once the camera is
installed, check the
angle. The lens angle
should not exceed
50˚ off of the center
axis. After vertical
and leveling
adjustments have
been made, it is
recommended to
rotate the camera
120 degrees in either
direction away from
its final position.
6. Replace the dome
by aligning the two
tic marks. The fit will
be tight to properly
seal the dome to the
rubber gasket
surrounding the lens
used to prevent any
IR LEDs from reflect-
ing back into the
lens. Rotate the
dome back 120
degrees so the
camera is now
facing the correct
direction and the
dome is locked
to the base.
Remove
Dome
Align
tic marks
FOCUS
(Near-Far)
Point tic-mark
towards desired
focus area
ZOOM
(Tele-Wide)
Point lens 120°
from desired
focus area
before replacing
the dome
Maximum Lens Angle
50˚
50˚
120111