GSM PHONE BLOCKER WCUT-T Series
1) The system is set to the maximum output power (1W) when shipped from the factory
2) Take out rubber rids on the cover of the system
3) Right hole is for high band and left hole is for low band
4) Turn the output power controller to clockwise direction with cross screw driver
5) Turn it little by little until you get the desired coverage. You can check it with handset.
6) After you set it, please make sure you put rubber rids on the hole back.
7. TROUBLE SHOOTING
1)
When LED lamp is not turned on after connecting AC Adaptor and turning on the switch;
a.
Check DC Jack is connected correctly
b.
Check AC Adaptor is connected to a socket correctly
2)
When you don’t get enough coverage
a.
Check if high band antenna and low band antenna are switched (a antenna without a ring : low
band, red ring antenna: high band)
b.
Check if there is a BTS around you. If there is, you will have to use more than one system to
have enough coverage since the output power of blocking system can not surpass the output
power of BTS.
3)
When system doesn’t work even LED is on.
a.
Check if high band antenna and low band antenna are switched (a antenna without a ring : low
band, red ring antenna: high band)
b.
Ask for technical help from where you purchased
DISCLAIMER
THE PURCHASER ASSUMES ALL LIABILITY ASSOCIATED WITH THE OPERATION OF WCUT-
T SERIES CELLULAR PHONE BLOCKING SYSTEM. WIRELESS TSUKAMOTO, CO., LTD. AND
ITS DISTRIBUTORS, HEREBY RELINQUISH ALL RISK AND LIABILITY WITH THE USE OF WC
UT-T SEIRES TO THE USER OF THE PRODUCT.
Wireless Tsukamoto Co., Ltd. 5/5
MTQP720-1
Rev.0
