6
Disconnecting A W-BRIDGE Wireless unit
1. Press and hold the transmitter <FUNCTION> button for 5 seconds.
The transmitter will disconnect from all receivers. The DMX LED indicators on the
receivers will then beturned off.
2. Press and hold each receiver’s <FUNCTION> button for 5 seconds.
Each receiver will disconnect from the transmitter, and its DMX LED indicator then
will be turned off.
Frequency/Mode Change
(Performed only on transceivers)
There are 3 different modes (frequencies) that you can manually choose from.
They are recognizable by the status of the Mode LED:
• Mode 1: OFF
• Mode 2: Blinking
• Mode 3: ON
1. To manually change the mode, hold the <FUNCTION> button for 8 seconds until
the DMX indicator turns off.
2. Press the <FUNCTION> button to switch between modes.
3. Press and hold the <FUNCTION> button for 7 seconds, and the transmitter will
begin transmitting the DMX signal through the newly set frequency.
Set a Transceiver to Transmit or Receive
Turn the power off, then turn it back on. Press the <FUNCTION> button for 2
seconds, it will switch from a transmitter to receiver or a receiver to transmitter. If
during this process you see the DMX indicator change, it is a transmitter, otherwise
it is a receiver.
Point-2-Point Operation
Basic Point-2-point systems are used when you want to send wireless DMX data
from a console to a single receiver. As the receiver accepts all 512 DMX channels
from the transmitter, you can easily daisy chain more fixtures by cable from the
fixture connected to wireless connection.
Multipoint-2-Multipoint Operation
Up to 16 universes of DMX can be transmitted simultaneously using a multipoint to
multipoint approach.All receivers in a multipoint system will listen only to the
designated transmitter without any delays or interference from the systems working
alongside.
Need more receivers?
Simply add as many receivers as desired to the transmitter, assigning them with a
simple button push.
