hörbert – automatic shutdown – installation manual
Page 1/7
09.02.18 16:00:00
Dear customer,
this additional piece of electronics switches off your hörbert after a selectable time. In addition, it offers
adjustable protection for your batteries. With some manual skill you can carry out the conversion yourself. To
do this, please follow the steps listed here carefully and make sure not to damage any surrounding parts of
your hörbert.
Your work surface should be soft enough not to scratch hörbert; and thick enough so that you do not damage
your table during the conversion. Please provide sufficient light to facilitate your work.
If you have any questions or problems, our service team will be happy to help you:
Use the contact form at www.hoerbert.com/service
By email:
By phone: +49 (0)7022 506420
Video Tutorial
https://www.hoerbert.com/videos
•
Please take 2 minutes to give us your feedback regarding the automatic shutdown:
Here you will find the online questionnaire. Thank you for your support!
https://www.hoerbert.com/shutdown-questionnaire
The conversion consists of 2 parts:
1. removal of the existing on/off switch
2. installation of the automatic switch-off module instead of the previous switch
You’ll need the following tools:
1x coin
1x cord
1x nut or wrench SW14
1x tweezers, preferably with bent tip
1x scratch protection (supplied)
1x conversion electronics (supplied)
Removal of the existing on/off switch:
1.
Open the sliding cover and put it aside. To loosen the screw, you can use a coin
Turn the coin counterclockwise to open the screw.
