Wintriss SmartPAC2, Руководство пользователя

Страница: 173 / 383

1126700 SmartPAC 2 User Manual
5-30 Program Mode
Viewing and Changing Sensor Settings
When you finish making settings for a sensor, you are taken to a screen like the one shown in
Figure 5-30, which displays all your sensor settings.
This screen also displays whenever you select a programmed sensor on the Die Protection
Sensor Menu.
To change sensor settings, do the following:
1.
On the Sensor Settings screen, select the setting you want to change. The screen on which
that setting is programmed displays. For example, if you select the SENSOR NAME
setting, the Sensor Names screen (Figure 5-22, page 5-22) displays.
2.
Change the setting on the displayed screen.
3.
Press RESET when you are finished to return to the Sensor Settings screen.
4.
Repeat steps 1 to 3 for each setting you want to change.
5.
Press RESET when you have finished changing settings on the Sensor Settings screen.
You are returned to the Die Protection Sensor Menu.
Viewing the Sensor Summary
You can view a summary of the settings that have been made for all programmed sensors
shown on the Die Protection Sensor Menu, including the critical angle that has been set for the
tool. To view the summary, do the following:
1.
On the Die Protection Sensor Menu, press F6 (View Sensor Summary). The Sensor
Summary screen, shown in Figure 5-31, page 5-31, displays. This screen shows the
sensor name, sensor type, stop type, and the Ready signal On and Off angles for Green,
Green Quick Check, and Green Constant sensors or the stroke count for Green Special
sensors.
Figure 5-30. Sensor Settings Screen