Wintriss SmartPAC2, Руководство пользователя

Страница: 171 / 383

1126700 SmartPAC 2 User Manual
5-28 Program Mode
To set the Ready signal, do the following:
1.
On the Ready Signal Programming screen, set the Ready On angle on the crank angle
clock, using the Left (

) and Right (

) cursor keys.
As you press the Left (

) cursor key, the On cursor moves counterclockwise around the
display, and the On angle value decreases. When you press the Right (

) cursor key, the
On cursor moves clockwise around the display, and the On angle value increases.
The precise On angle value is displayed in the window inside the clock display.
2.
Set the Ready Off angle on the crank angle clock, using the Up (

) and Down (

) cursor
keys.
As you press the Up (

) cursor key, the Off cursor moves clockwise around the display,
and the Off angle increases. As you press the Down (

) cursor key, the Off cursor moves
counterclockwise around the display, and the Off angle decreases.
The precise Off angle value is displayed in the window inside the clock display.
3.
When you have finished setting the Ready On and Ready Off angles, press RESET. The
Sensor Settings screen (see Figure 5-30, page 5-30) displays with all your sensor settings
shown.
Figure 5-28. Ready Signal Programming Screen
The Ready signal you set in Program mode can be fine-tuned in Run mode after you have run the
press. See Adjusting the Ready Signal for Green Sensors, page 6-10 for details.
If you do not know how to use the cursor keys to set sensor Ready signal timing, see page 3-6.
Highlighted arc
shows duration
of Ready signal
Ready signal
On and Off angles
NOTICE
NOTICE