Wintriss SmartPAC2, Руководство пользователя

Страница: 112 / 383

SmartPAC 2 User Manual 1126700
Initialization Mode 4-15
2.
With the highlight bar on ADVANCE CONST. 1, press ENTER. The Numeric Entry
window (see Figure 4-7, page 4-10) displays.
3.
Key in a value (maximum is 500) in the Numeric Entry window, using the numeric keypad
or the Up (

) and Down (

) cursor keys, then press ENTER.
4.
Repeat steps 2 and 3 for ADVANCE CONST. 2 (maximum value is 500) and SLOW RPM
(maximum value is 2000).
5.
When you are done, press RESET to return to the Main Initialization Menu.
SET GLOBAL CAMS (Optional)
(INITIALIZATION – SET GLOBAL CAMS)
AUTO ADVANCE IS ADJUSTABLE
SmartPAC 2 allows you to adjust Auto Advance and Slow RPM settings in Initialization
mode while the press is running. The angle at which an Auto Advance cam turns on is
shown in the upper right corner of the screen under the caption PRESS ANGLE, enabling
you to see the effect of different settings.
PROGRAMMABLE CAM SWITCH NOT FOR SAFETY USE
Use SmartPAC 2’s programmable cam switch to control auxiliary functions only. The SmartPAC 2
programmable cam capability should never be used to provide timing signals for any safety use
including clutch/brake control or muting of light curtains.
Failure to comply with these instructions will result in death or serious injury.
Set as global cams only cam channels that perform identically regardless of the tool installed.
You can use a “global” cam with the mechanical cam switch for Top Stop, if one has been installed,
to assist in adjusting top stop and to use the Auto Advance feature to mimic Auto-compensated
Top Stop (ACTS). See Wiring the ProCamPAC Output with Your Mechanical Top Stop Cam
Switch (Optional), page 2-32.
CHANNELS 6, 7 AND 8 CANNOT BE USED FOR GLOBAL CAMS
You can set any channel as a global cam except channels 6, 7 and 8.
NOTICE
DANGER
!
NOTICE
NOTICE
NOTICE