Wintriss SmartPAC2, Руководство пользователя

Страница: 105 / 383

1126700 SmartPAC 2 User Manual
4-8 Initialization Mode
PRESS NAME
(INITIALIZATION – PRESS NAME)
This item enables you to name the press on which SmartPAC 2 is installed. When you select
PRESS NAME, the Alphabetic Entry window opens (see Figure 4-5), allowing you to enter
the characters for the press name you want, using any combination of alphabetic characters,
numbers and symbols.
To enter a press name in the Alphabetic Entry window, do the following:
1.
To key in letters and symbols, highlight each character, using the Up (

), Down (

), Left
(

), and Right (

) cursor keys, then press ENTER. Pressing the CLEAR key clears the
text.
To key in numbers, use the numeric keypad, then press ENTER.
2.
To accept your entry, press F6. To cancel your selection, press RESET.
SET BRAKE MONITOR
(INITIALIZATION – SET BRAKE MONITOR)
This item enables you to set the limits for your press’s stopping time and starting time. These
settings are made on the Brake Monitor screen, which is shown in Figure 4-6, page 4-9.
The stopping time is the time that it takes the crankshaft to stop once the dual safety valve
(DSV) has been de-energized. The Brake Monitor checks the stopping time of the press on
every top-stop, and whenever the stopping time approaches to within 10 milliseconds of the
stop time limit you set on this screen, the Brake Warning LED on the SmartPAC 2 front panel
blinks. This warning alerts maintenance personnel to perform the necessary repairs on the
press.
Whenever the press’s stopping time exceeds the stop time limit, SmartPAC 2 displays the
“STOP TIME EXCEEDED” message (see page 7-6) and prevents the press from operating
further until the problem has been corrected.
You can use a separate computer keyboard to enter the press name. See page 4-45.
Figure 4-5. Alphabetic Entry Window
NOTICE