Wintriss SmartPAC 2, Руководство пользователя

Страница: 221 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Initialization Mode 4-35
Press Options
(INITIALIZATION – PRESS CONTROL – PRESS OPTIONS)
The Press Options item on the WPC Initialization Menu gives you access to the Press Control
Option Switch Menu, on which you can set the positions of eight switches on switch block
S101 on the WPC 2000 Main Processor board and make three operator mode settings. You
can set two additional switches on S102, but this must be done on the Main Processor board
itself.
Setting Option Switches on S101
The SW1 through SW8 items control the position of switches on switch block S101 on the
WPC 2000 Main Processor board. Switches can be set to OPEN or CLOSED. To set one of
these items, do the following:
1.
On the Press Control Option Switch Menu, move the highlight bar to the setting for the
switch you want.
2.
Press ENTER until the setting you want is displayed.
3.
Repeat steps 1 and 2 for each switch you want to set.
4.
Press RESET when you are finished to save your settings and return to the WPC
Initialization Menu.
Settings for each switch are documented in the following sections.
Figure 4-23. Press Control Option Switch Menu
CYCLE POWER AFTER CHANGING OPTION SWITCH SETTINGS
Whenever you change an option switch setting, you must power down the WPC 2000 and power it
back up again in order to enable the new setting. If you do not cycle power, the previous switch
setting will remain in effect.
NOTICE