13
Tilling Depth Adjustment
Before installation/maintenance, ensure both tractor and
attachment are stationary, with the hydraulic lift system in a
neutral position and the ignition key removed.
We recommend a maximum working depth of 15cm for soft soil, and
13cm for dense/dry soils.
The initial set up of the tractor
’
s top linkage arm and the linkage set up
will influence tilling. But it is also important to set up the side skids to get
the correct depth when cultivating.
Moving the skids down and further away from the body will create a
shallower working depth. Moving the skids upwards closer to the
machine will increase the working depth achieved.
1.
Remove bolt (
5
) and loosen off bolts (
6
).
2.
Replace bolt
(5)
into the selected hole (
7
) and tighten.
3.
Re
-
tighten bolts (
6
) in position.
4.
Repeat steps (
1
-
4
) above on the other side of the machine.
5
7
5
6
6
7
14
Servicing & Maintenance
Store all lubricants away from excessive heat, dust, moisture and
contaminants. Before maintenance, ensure both tractor and
attachment are stationary, with the hydraulic lift system in a neutral
position and the ignition key removed.
Wipe grease nipples with a clean cloth before greasing to avoid injecting
any dirt/grit. Press a multi
-
purpose lithium
-
based grease into each grease
nipple 3 to 5 times. Use a handheld grease gun for best results. Replace or
repair broken grease points immediately. Grease both lubrication points
on either end of the PTO shaft, and apply grease to the inner shaft.
Grease the blade rotor bearing (
1
). The left bearing is within the gear
reservoir and is lubricated by
the same oil (see
page 11 on Gear Reservoir
Oil Change).
1
Содержание WRT Series
Страница 10: ...19 Notes 20 Parts Diagram 2 ...