Winterthur Gas X40-B, Руководство по обслуживанию

Страница: 205 / 495

Maintenance
3103 − 1/A1
Winterthur Gas & Diesel Ltd.
3/ 3
4. Calculate
Fig. 3
STROKE
D
94305
n BDC
n TDC
The difference between the values shown shows the crank deflection during one full
turn of the crankshaft ( Fig. 3 ).
Where values are measured that are more than the maximum permitted limits, the
cause must be found. The necessary procedures must then be done to repair the
problem (defective main bearing, engine stay changed because of hull deformation,
loose hold-down bolts, defective propeller shaft bearings or equipment 94305, etc.).
The limits are applicable for all conditions of ship service after delivery, i.e.:
D The draught and trim are in the limits for usual operation.
D The engine is stopped and is hot or cold.
D If the engine is in a cold condition the tank heating (which is close to or below the
main engine and the pre-heater of the main lubricating oil separator) must not be
in operation for a minimum of eight hours before the procedure given in
paragraph 2 .
Usual Operation: Crank-web Deflection Limits (mm)
Vertical Horizontal
Cylinder No. 1
(Driving end)
Cylinder No. 2
to next to last
cylinder
Last cylinder
(Free end)
All cylinders
Note 1) Note 2)
0.32
− 0.32
0.23
− 0.23
0.23
− 0.23
0.23
− 0.32
0.11
− 0.11
1) For engine without a torsional vibration damper or front disc or free end PTO.
2) For engine with a torsional vibration damper or front disc or free end PTO.
Speak to Wärtsilä Switzerland, if the final indications are more than the limits given in
the table above.
2016
Crank Deflection − Measure