18 89005779
Display Cause
Remedy
Display shows:
Water stop valve closed
Malfunction
Switch off machine (press on-off switch). Then
Err
will appear on the control panel accompa-
nied by a fault code.
If error code 20 is shown, close the water shut-
off valve and notify Winterhalter customer ser-
vice.
If other error codes are displayed, check
whether the water shut-off valve is opened.
Then switch on the machine again.
If the fault message appears again, note the
fault code and get in touch with the appropriate
Winterhalter customer service
Key flashes blue
If the cutlery has not been properly
cleared away beforehand, so much dirt
may have collected on the flat filter and
in the filter cassette that the rinsing
program can no longer run properly.
The washing pump switches off and the
program key flashes blue.
•
Switch off machine, the program key will
continue to flash.
•
Take out filters, clean and replace them.
•
After two minutes, the flashing will stop.
Switch the machine back on and con-
tinue to run it.
•
Clear away the cutlery more carefully to
avoid further malfunctions.
11.2 Error alarms in machines with optional extras
Display
Possible cause
Remedy
Lack of detergent or rinse additive
Re-fill detergent or rinse additive
Out of regeneration salt
Refill with regeneration salt and run one wash
programme (see also Page 8)
External water treatment system needs
regenerating
Regenerate external water treatment system
Peak load cut-off active
Wait until the peak load cut-off switches on the
machine completely again.
DOS
