12
c. (Optional) Short press measurement button 1 to flip the
page.
d. Select start item and press OK to initialize with "S1: ADC"
showing up. At this time, the first three items read
"Number--Number", the right side represents ADC value,
and the left side represents the converted vibration value.
e. Display under different calibration items:
(1) Press again to perform zero calibration with “S2: Zero”
showing up, and wait until progress bar reaches 100%.
(2) Adjust the output of vibrating machine to a stable state
corresponding to the condition above. Press OK button
again to calibrate slope value with “S2: Slope” showing up,
and wait until progress bar reaches 100%.
(3) If calibration is successful, “success” is displayed above
progress bar, otherwise “Fail” shows up. The same is for
the other calibration items.
f. After completing the required calibration, press Menu
button to return.
g. If calibration value is wrong, users can restore factory
setting in the settings.
H. Other notices
1. When viewing data, converted values are displayed
according to the set frequency (high or low).
2. When the amount of data is large, it will take some time to
enter file interface and operation also needs some response
time. It is recommended to delete some unnecessary data.
3. When acceleration value is beyond measurement, try to
switch frequency.
4. The meter will automatically shut down when the battery is low.
Comparison table for vibration intensity
5. Machine level is represented by green, yellow, orange,
red status bar in the full display measurement interface.
Refer to the figure below for details.
13
WARRANTY:
1. Please refer to warranty card provided for your warranty.
2. If the user disassembles our products and for damages caused
by improper transportation, improper storage after purchase,
and failure to operate according to instruction, and for anyone
who smears warranty card or does not possess purchase
certificate, our company does not guarantee warranty.
Machinery
Class I
Class II
Class III
Class IV
V
ibration speed
V
rms
mm/s
Good
Satisfactory
Unsatisfactory
Unacceptable
0
.
28
0
.
45
0
.
71
1
.
12
1
.
80
2
.
80
4
.
50
7
.
10
11
.
20
18
.
00
28
.
00
45
.
90
Vibration intensity (ISO 10816-1)
small
machine
medium
machine
large
hard base
large
soft base
Specific Declarations:
Our company shall hold no any responisibility resulting from using
output from this product as an direct or indirect evidence.
We reserves the right to modify product design and specification
without notice.
