SBC35-C398/Setup
v1.0
www.winsystems.com
Page 6
7.
Setup
7.1
Power Setup
Power can be provided to the SBC35-C398 through either of two inputs:
1. +10 V DC to +50 V DC power supply connected to the green power connector at
J17.
2. IEEE 802.3 at compliant Power over Ethernet (PoE).
See “Power up” on page 7 for additional information.
7.2
Serial Console Setup
A serial cable connected to the SBC and a secondary system with a terminal emulator
program is required to view the serial console output of the SBC35-C398 SBC and to
configure the SBC through the U-Boot boot loader interface. The default serial port
settings are:
•
Baud rate = 115200
•
Data width = 8 bits
•
Parity = None
•
Stop = 1 bit
•
Flow Control = Off
See “Console” on page 11 for additional information.
7.3
Keyboard and Mouse
Connect a keyboard and mouse to the SBC35-C398 through the USB connectors.
7.4
Audio and Video Display Setup
The SBC35-C398 can provide three separate video outputs, one HDMI and two LVDS.
See “Video Output” on page 11 for additional information.
An audio cable bundle is available from WinSystems for the SBC35-C398Q board (P/N
CBL-AUDIO2-202-12D). It attaches to
J12
and brings the analog audio signals out to
Use Proper Power Connections (Voltage)
—When verifying the voltage, measure it
at the power connector on the SBC35-C398. Measuring it at the power supply does
not account for voltage drop through the wire and connectors.
Power the SBC35-C398 using Power over Ethernet (J16 RJ45, PoE IEEE802.3) or
Auxiliary Input (J17, +10 V DC to + 50 V DC). Verify the power connections. Incorrect
voltages can cause catastrophic damage.
