ITX-P-C444/
v1.0
www.winsystems.com
Page 23
embedded computer module can cause the BGA to tear away from the
printed circuit board.
Mounting holes
—The mounting holes are plated on the top, bottom, and
through the barrel of the hole. Traces are often routed in the inner layers
right below, above, or around the mounting holes.
• Never use a drill or any other tool in an attempt to make the holes
larger.
• Never use screws with oversized heads. The head could come in con-
tact with nearby components causing a short or physical damage.
• Never use self-tapping screws; they compromise the walls of the
mounting hole.
• Never use oversized screws that cut into the walls of the mounting
holes.
• Always use all of the mounting holes. By using all of the mounting
holes, you provide the support the embedded computer module
needs to prevent bending or flexing.
Plug or unplug connectors only on fully mounted boards
—Never plug
or unplug connectors on a board that is not fully mounted. Many of the
connectors fit rather tightly and the force needed to plug or unplug them
could cause the embedded computer module to be flexed.
Avoid cutting the ITX-P-C444
—Never use star washers or any fastening
hardware that cut into the ITX-P-C444.
Avoid over-tightening of mounting hardware
—Causing the area
around the mounting holes to compress could damage interlayer traces
around the mounting holes.
Use appropriate tools
—Always use tools that are appropriate for
working with small hardware. Large tools can damage components
around the mounting holes.
Avoid conductive surfaces
—Never allow the embedded computer
module to be placed on a conductive surface. Many embedded systems
use a battery to back up the clock-calendar and CMOS memory. A
conductive surface such as a metal bench can short the battery causing
premature failure.
Conformal Coating
Applying conformal coating to a WINSYSTEMS product does not in itself
void the product warranty, if it is properly removed prior to return.
Coating can change thermal characteristics and impedes our ability to
test, diagnose, and repair products. Any coated product sent to
WINSYSTEMS for repair will be returned at customer expense and no
service will be performed.
