Antenna Systems
6.
Now install the vertical plane companion antenna onto the top tube as shown. Secure the antenna to the upper boom
using the two 8G self tapping screws provided. These should be hand tight. Note: If using a cordless drill or driver, be
careful to set a low torque setting initially, so as not to strip the formed thread in the aluminium upper boom.
7.
The coaxial cables may now be installed. Attach the Horizontal antenna to the Winsig 3.0 Companion antenna using an
11mm spanner or shifter. Note: The connectors have inbuilt rubber sealing mechanisms, and so the need be made
firm, but not over tight. Slide the connector boot on the cable over the connector to protect the joint.
8.
The existing coaxial cable from the original antenna can now be installed onto the female lead of the Winsig 3.0 Com-
panion antenna, and the protection boot slid into place. All connectors are male-to-female, and cannot be incorrectly
installed.
9.
The installation is now complete. Return to the inside of the van, fully raise the antenna and orient toward the signal
source. Make sure the power supply (240v AC or 12v DC) is switched on, and remember to retune your TV, as you
should now be receiving more channels in both the vertical and horizontal planes.
As mentioned earlier, several alternative installations are possible. This document shows the two antennas pointing in oppo-
site directions. One alternative is to have the Winsig 3.0 companion antenna installed so that is faces in the same direction to
the original horizontal antenna. This orientation will function equally well, but clearance checks when fully down are required
prior to installation. The 150mm dimension can also be varied to ensure clearance to existing components when the antennas
are stowed. The important characteristics are that the Winsig antenna is vertical, and has clear line of sight above existing
components on the roof of the van when fully raised. (such as an air conditioner)
We love feedback. Please like our page on Facebook and send us an e-mail with your thoughts or a photo of your new installa-
tion at [email protected] . We will try to make sure your photo makes it onto our page.
