Antenna Systems
Winsig 3.0 Companion Installation Instructions
The WINSIG 3.0 Companion is a vertical plane log periodic antenna. It is design to be installed onto the vertical antenna boom
of your Winegard Sensar or Antennatek Signal Commander antenna and will complement the horizontal signals.
Note: Before commencing installation of the antenna, a clearance check should be completed with the antenna in the
locked down position. All caravan roofs are different, and obstructions such as air conditioners and solar cells can cause
interference with this companion antenna in the full down position. Several alternative installation positions are possible.
INSTALLATION OF WINSIG 3.0 COMPANION ANTENNA
1.
Before beginning installation, ensure all power (12v or 240v) is switched off.
2.
To begin the installation, first elevate the existing antenna and turn 90 to the stowed position. Then lower the antenna
to a position in which it extends laterally over the edge of the roof of the Caravan or RV. This will allow easy access to
the antenna with the use of a ladder.
3.
Loosen the coaxial cable from the existing antenna with an 11mm spanner, or similar, and once removed, lay this down
along the boom for attachment to the companion antenna later.
4.
Working with the back of the antenna facing you, measure 150mm from the upper mounting pin, to locate the first
mounting hole on the upper boom. Place the companion antenna in this position with the angle bracket hard against
the boom, and mark the position of the holes, using the companion antenna mounting bracket as a template. Note:
Make sure that you check your measurements against the diagram shown above before proceeding.
5.
Centre punch the hole positions, and drill two 3.0mm holes in the upper boom.
Drill 3.0mm holes
2 places
