Winplus Yada, Руководство по установке и эксплуатации

Страница: 11 / 16

• There are “L” & “R” labels on wiring harness, please
connect sensor to corresponding connector
• Please confirm the sensor “UP” side faces upward and
the installation height is high enough
• Please make sure that the wiring harness is fixed well and
far away from vent-pipe
• Please remove burrs and flash from the hole, make the
hole fit for sensor, not too tight or loose, otherwise the
system should be abnormal
• The connector of the control box should face ground to
prevent water
• Clip the two warning LEDs into the plastic weatherstrips
on the A pillar
LED Display
distance in meter
left side right side
Operations
NOTE:
If the unit is installed as outlined, it should ONLY
function when the Left and Right turn signals are activated:
Activate/Deactivate Left Sensors:
• To Activate turn your left turn signal On
• The unit will beep
• The Left LED Warning lights will blink when there is an
obstacle on the vehicle’s left blind spot.
• The display will show the distance of the obstacle from
the left blind spot sensor
• To deactivate turn your left turn signal Off
Activate/Deactivate Right Sensors:
• To Activate turn your right turn signal On
• The unit will beep
• The Right LED Warning lights will blink when there is an
obstacle on the vehicle’s right blind spot.
• The display will show the distance of the obstacle from
the right blind spot sensor
• To deactivate turn your right turn signal Off
WARNING: Do not solely rely on the Blind Spot Assist
System. Always practice safe driving habit. Always do a
visual check of your vehicle’s surrounding before turning or
switching lanes.
10