SOLID TOP BUTTERFLY LEAF PEDESTAL TABLE
TBSR-10369BC-CNGN
MADE IN MALAYSIA
PAGE 2 OF 3
STEP 2
NOTE :
THE UNIT SHOULD BE ASSEMBLED BY 2 OR MORE PEOPLE.
ASSEMBLY
STEP 1
Hex Nut
Hex Nut(5/16")
12 pcs
Lock Washer
Lock Washer(5/16")
5/16"
5/16"
12 pcs
Flat Washer
Flat Washer(5/16")
Pedestal
Leg
Level Glide
5/16"
12 pcs
Lock Washer
M6x13mm
10 pcs
Flat Washer
M6.5x16.5mm
10 pcs
Wrench
Wrench
1 pce
Allen Key
1 pce
M6x50mm
JCBC Bolt
10 pcs
HARDWARE PART :
Turn the pedestal upside down. Attach legs by inserting
hanger bolts through pre-drilled holes on pedestal.
Put a Flat Washers(5/16"), Lock Washers(5/16") and
Hex Nut(5/16") onto the hanger bolts then tighten with
the provided Wrench.
Position the table top upside down on a smooth, protective
surface such as carpet. Remove and discard the temporary
Wood Strip. Install the side panel and secure with
Flat Washers(M6.5x16.5mm), Lock Washers(M6x13mm) and
JCBC Bolt. Attach Mounting Plate as shown. Secure with
Flat Washers(M6.5x16.5mm), Lock Washers(M6x13mm) and
JCBC Bolt(M6x50mm), then tighten all JCBC bolts with Allen Key
provided.
STEP 3
Unlock the hooks underneath the table and pull the table top wide
open equally from both ends. Align and attach the table top to the
pedestal. Insert a Flat Washers(5/16"), Lock Washers(5/16") and
Hex Nuts(5/16") onto the hanger bolts. Tighten all Hex Nuts with the
provided Wrench.
Lock Washer(M6x13mm)
Lock Washer
(M6x13mm)
Allen Key
Allen Key
JCBC Bolt(M6x50mm)
JCBC Bolt
(M6x50mm)
Flat Washer(M6.5x16.5mm)
Flat Washer
(M6.5x16.5mm)
Mounting Plate
Side Panel
Lock Washer(5/16")
Flat Washer(5/16")
Wrench
Hex Nut(5/16")
Unlock Hook
Remove wood strip
CARE INSTRUCTION
~ Be sure to use the same type of polish consistenly.
Your furniture will appear cloudy or streaky if oil
based or wax based polishes are interchanged.
~ Spray your furniture surface evenly. Wipe in a
circular motion with a soft clean cloth.
IMPORTANT NOTE :
~ Please keep all hardware out of the reach of
children. Two or more people are needed for
assembly.
IMPORTANT NOTE :
1. Use only the hardware supplied.
2. Do not over-tighten bolts.
3. This item may require periodic tightening.
T1-VG4260-O & -C
