SECTION 9 –
FURNITURE AND SOFTGOODS
9-6
1. Get a partner to help you lift the table top
upward off the support tubes and set the table
top edgewise onto the floor to remove the
table leg tubes.
2. Pull the table leg tubes from the floor or table
sockets and store beneath dinette seat.
3. Place the table top onto the ledge of the dinette
seat.
4. Place the center back dinette cushion into
place over the table to complete the bed
conversion.
Reverse steps to reassemble to dinette
configuration.
PLEATED BLINDS
Your coach may feature pleated window
blinds for nighttime privacy and daytime room
darkening purposes.
They are raised or lowered by grasping the
bottom edge of the blind and moving it up or
down by hand.
A constant-tension cord system holds them at
the desired level without slipping.
Tension Adjustment
The tension of the pleated blinds can be
adjusted if they become loose and will not stay up
when raised, or they are too tight and are difficult
to raise and lower.
The tension cords are attached to spools at the
lower corners of the blinds as shown in the
following photo.
To Tighten Tension
Wrap the tension cords around the mounting
spools, one turn at a time, at both ends of the
shade. Check tension by raising and lowering a
few times. Repeat as necessary to obtain the
desired tension. Do not over-tighten.
To loosen tension
Unwrap the guide cords from the spools, one
turn at a time, until desired tension is achieved.
Preserving Shape
The pleated blinds are made using high
quality materials that are designed and woven to
retain their shape throughout their useful life.
Place table
top onto
ledge.