10-1
5 - DA
S
H
/
A
U
T
O
SECTION 10 – SLIDEOUT ROOMS AND LEVELING
SLIDEOUT ROOM LOCK
SYSTEM
The ignition key must be placed in the on or
run position to operate the slideout room(s). The
park brake must be applied for the room(s) to run.
Winnebago recommends running the engine
whenever you run the slideout rooms in or out,
the engine alternator should insure the rooms
have adequate 12-volt DC power to operate
correctly.
SLIDEOUT ROOM
RETRACTION (WITH SLIDING
BED)
–If Equipped
Your motorhome may be equipped with a
side-to-side sliding bed mechanism which
provides walk-around bed accommodation and
clearance to access the side cabinets.
This sliding bed mechanism is equipped with
an interlock feature, which will not allow you to
retract the passenger side slideout unless the bed
is positioned toward the driver side.
Further Information
For further sliding bed operating instructions,
refer to
Section 9 - Furniture and Softgoods
in
this manual.
SLIDEOUT ROOM
RETRACTION (WITH POWER
LIFT BED)
–If Equipped
Your motorhome may be equipped with a
power lift/lower mechanism that raises and
lowers the head of your bed to best suit your
comfort needs.
This power lift/lower mechanism is equipped
with an interlock feature, which will not allow
you to retract the bedroom slideout unless the bed
is in the fully upright position.
Further Information
For further power bed operating instructions,
refer to
Section 9 - Furniture and Softgoods
in
this manual.
NOTICE
Bed must be positioned toward the driver
side to fully retract slideroom.
NOTICE
Bed must be in the fully upright (vertical)
position to fully retract slideroom.
