![background image](http://html1.mh-extra.com/html/winnebago/chalet-27cr2006/chalet-27cr2006_manual_987474030.webp)
SECTION 5
– Dash / Auto
5-2
Class A
COMFORT CONTROLS
Controls for the air conditioner, heater,
defroster and vent are all combined into one
control panel. Refer to the following instructions
for use of individual controls.
Fan Switch
Smallest dot is lowest air movement; Largest
dot is maximum air movement. Fan will run at set
speed when mode knob is in any position except
Off. When mode knob is set to Off, the fan will
not run.
Temp Control
Blue = Cold / Red = Warm
Mode Selector Positions
Max A/C -
Cab air is recirculated (and re-cooled)
through air conditioner.
Norm A/C -
Directs outside air through air
conditioner cooling fins to reduce cab
temperature.
NOTE:The dash air conditioner is not designed
to cool the entire interior of the coach,
but is intended to cool the cab area only.
Vent -
Directs outside air through dash vents.
Incoming air temperature can be adjusted
using temp control knob, although cooling is
limited to a few degrees above ambient
outside air temperature.
Floor -
Directs most air to floor vents and small
amount to windshield defrost vents.
Mix -
Splits air between floor and windshield
defrost vents.
Def -
Directs most air to windshield defrost vents
and small amount to floor vents.
Off -
When no heating, cooling or ventilation are
not required; closes all air dampers and turns
fan off.
Rear Auto Heater
To provide auxiliary heat to the rear of the
vehicle, turn the rear heater fan switch to the
desired speed. The switch has three positions: Hi,
Low and the middle position is Off.
Aux Fan Switch
The two-speed auxiliary fans are intended to
assist the automotive windshield defroster
system in clearing fog and frost in cold weather
or humid conditions. The middle position on the
switch is OFF.
Fan Switch
Temp Control
Mode Selector