![background image](http://html1.mh-extra.com/html/winnebago/2013-adventurer/2013-adventurer_operators-manual_987453047.webp)
4-9
SECTION 4 –
APPLIANCES AND SYSTEMS
NOTE: The Thermostat does not automatically
switch between heating and cooling. You
must manually select desired system.
Heating
1. Open the LP gas tank valve by turning fully
counter-clockwise.
2. Press the System Button and select “Heat”.
3. Press the Zone Button and select desired
zone(s).
4. Press the Mode Button and toggle between
settings to select either “Gas Heat” (for
Propane Furnace) or “Heat Elec” (for Heat
Pump).
5. Adjust the temperature setpoint to personal
preference if needed. See “Changing
Temperature Setpoints”.
Cooling (A/C)
1. Press the System Button and select “Cool”.
2. Press the Zone Button and select desired
zone(s).
3. Press the Mode Button and toggle to desired
setting:
•
Cool/Auto:
Allows the fan speed to vary
depending on the cooling needs. This is the
default setting.
•
Cool High/Cool Low:
Sets the fan speed to
run continuously at high or low, but the upper
unit will cycle when cooling is needed.
•
Fan High/Fan Low:
Sets the fan to run
continuously at high or low speed. The upper
cooling unit will not run to produce cooling.
Setpoint is not adjustable in this mode.
•
Off:
Turns the upper unit off for the zone
displayed. By continuing to press the Mode
Button, you can toggle through the settings for
the zone displayed until you have reached
your desired setting. Setpoint is not adjustable
in this mode.
4. Adjust the temperature setpoint to personal
preference if needed. See “Changing
Temperature Setpoints”.
5. Once you have established the settings for
Zone 1, press the Zone Button to store settings
in Thermostat memory.
NOTE: Repeat steps for each zone.
Heat Pump
Your coach is equipped with an air source
Heat Pump built into the air conditioning system.
Because the Heat Pump operates on electricity, it
provides economical heat inside your coach and
helps reduce the use of propane gas for heating in
cooler weather.
A Heat Pump can be thought of as an air
conditioner running in reverse. An air
conditioner absorbs heat from the air on the
inside of the coach and moves it to the outside.
The Heat Pump does exactly the opposite. Even
cold air contains some heat, so a Heat Pump will
extract heat from the outside air on a cold day and
carry it to the inside of the coach to maintain a
comfortable temperature.
The efficiency of a Heat Pump decreases as
the outdoor air temperature drops, so
supplementary heat is often needed when the
outside temperature nears freezing. This system
is set to automatically start the propane furnace to
assist the Heat Pump if room temperature cools to
5 degrees or more below the Thermostat set
temperature. You may wish to manually switch
to propane furnace heat to maintain a higher
temperature when outside temperatures begin to
reduce the efficiency of the Heat Pump. The Heat
Pump will not operate when the outside
temperature falls below 36 degrees F.
Electronic Thermostat
(Located near monitor panel)
• System
Button
• Zone
Button
• Mode
Button
• Setpoint
Buttons
• LCD
Display
Screen