3-9
SECTION 3 –
DRIVING YOUR MOTOR HOME
GP-GO
™
PORTABLE
NAVIGATION SYSTEM
–If Equipped
GPgo - “GPS on the Go” can help you
confidently chart your course through the most
dense concrete jungle or remote country
backroad using global satellite positioning
technology - and it is portable, so you can control
it from the dash in your RV, or remove it and take
it with you in another vehicle (separate docking
station included).
To install the GPS unit, open the cradle by
pushing the button at the top of the docking
station. The cradle will tip forward allowing you
to slide the GPS unit into the cradle. Push the
GPS unit back into the cradle until it latches.
You now will be able to operate your GPS unit
via the dash-mounted display and remote control.
Navigational information is displayed on
either the GPS display panel or the rear monitor
screen using the GPS remote control.
To view the GPS on the rear monitor, push the
“Aux Input” button on the rear monitor.
NOTE: Pressing the Aux Input button and
turning up the volume on the rearview
monitor also increases the sound
capacity of the voice commands when
driving. The rearview monitor speaker is
used to supplement the primary
navigation monitor speaker. You can
adjust the volume on the rearview
Driver Side Sunvisor Switches
(center visor equipped on 40KD model only)
Passenger Side Sunvisor Switch
Portable GPS Navigation
Docking Station
(Located inside Driver’s Side
Overhead Compartment)
