SECTION 8 –
ENTERTAINMENT
8-6
Cable
(Park cable input located in power cord
compartment)
•
Turn Off antenna booster inside coach. See
above photo.
•
Turn On TV and tune to desired channel.
Video Programming from the Video
Selection Box
•
Turn On video
selection box and
select desired input
(Satellite, DVD, or
Aux) for TV2.
•
Turn On TV and press the SOURCE or
INPUT button on the TV or TV remote to
select INPUT1 or AV1.
Play TV Through Stereo Speakers
The exterior entertainment center TV is
connected to the video selection box, the rooftop
antenna, and the park cable input. To play this
signal through the stereo speakers:
•
Tune TV to desired channel or input.
•
Turn On the radio and press the MODE button
on the remote or the radio until it displays AV-
IN1.
•
Adjust the volume on the TV or the radio for
desired level.
Further Information
For further information and operating
instructions, see the manufacturer’s information
included in your InfoCase.
COMPACT DISC CHANGER
–If Equipped
The remote audio CD changer is located out of
sight in the driver side overhead front cabinet.
The changer cartridge holds up to 10 compact
discs for hours of listening enjoyment. The CD
changer operates through the dash radio.
Further Information
See the Compact Disc Changer System
operating guide in your InfoCase for complete
instructions on how to load CD’s, operate the
changer with your radio and troubleshoot basic
problems.
TV ANTENNA
The TV antenna on your motor home can be
easily raised, rotated a full 360
°
and lowered
from inside the vehicle by simply turning a crank
or directional handle. A built-in signal amplifier
designed to strengthen signals, is controlled by a
power switch built into the optional video
selector panel or on a wall plate assembly.
See the antenna manufacturer’s operation,
care and maintenance information in your
InfoCase.
Raising Antenna to Operating Position
Turn elevating crank clockwise in “UP”
direction until some resistance to turning is noted
(about 13 turns). Antenna is now in operating
position.
Turn amplifier power switch “ON” to receive TV
signal.
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.