
SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
10-12
•
Use a 3/4” socket and ratchet wrench on the
motor gearbox shaft to crank the room in or
out as needed. Crank both sides of the room
alternately and equally to avoid wedging the
room.
If help is available, a second person (with a
duplicate socket and ratchet) cranking the
other end simultaneously will greatly speed
up the process.
•
Crank the room until it is just “snugged up.”
Do not overcrank or you could damage the
gear assembly.
•
While maintaining pressure on ratchet
wrenches, re-engage the motor brake by
moving lever clockwise slightly (to right
when facing end of motor).
•
Reconnect motor power lead to wiring
harness.
•
Fasten slideout room travel latching device (if
equipped) inside the coach before driving the
vehicle.
•
See your dealer for service of the slideout
mechanism before using again.
Further Information
See the Slideout Room operating guide
included in your InfoCase for further instructions
and troubleshooting information.
SLIDEOUT EMERGENCY
RETRACTION – HYDRAULIC
(Front Slideout Rooms)
-If Equipped
Crank-In Procedure
(If slideout room will not retract using
control switch)
Step 1: Relieve Hydraulic Line Pressure
•
Open the slideout solenoid valves on top of
the hydraulic pump to release hydraulic line
pressure and let fluid bypass into the fluid
reservoir. To access the pump, open the
storage compartment door directly behind the
front tire.
NOTE: The hydraulic pump is equipped with
two sets of solenoid valves. One set
controls the slideout rooms and the other
set controls the leveling jacks.
See the Hydraulic Leveling System/
Front Slideout Motor/Gearbox Units
(Located near ceiling of storage compartment
beneath each end of slideout room)
3) Use 3/4”socket on gearbox
shaft. Crank both sides
equally to avoid wedging
2) Disconnect motor
power lead from
wiring harness
1) Lift tab inside
protrusion on boot to
disengage motor brake
WARNING
Stop engine, place transmission in park
position, and apply parking brake before
lying beneath vehicle for this procedure.
Hydraulic Pump Access
(Open storage compartment door behind
driver’s side front tire)