13-5
SECTION 13
SLIDEOUT ROOM
14 - SLIDEO
UT R
OOM
13 - SLIDEOUT ROOM
It may be necessary to move the handle slight-
ly from side to side to fit it onto the shaft. The
crank handle will only move the arm that it is in-
serted into. Consequently you will need to alter-
nate between each crank handle on each side to
move the room in or out. If help is available a sec-
ond person cranking on the other handle simulta-
neously will greatly speed up the process. At no
point in the cranking process should you let one
side get more than 2 inches (50 mm) ahead of the
other. The most effective way to retract the room
using a single person is to crank one side ahead of
the other, then crank the other side in (“walk” the
room in).
Troubleshooting
Problems Extending the Room
Set the Park Brake if the red Park Brake light
flashes while pressing the Extend button.
If an error is detected, the green LED on the
left side of the control panel will blink an error
code. If an error code appears, see the On Board
diagnostics section to determine the problem.
The error code must be cleared prior to operating
the room. To clear the error, press the “RESET”
button with a small tool such as a toothpick. Be-
fore operating the room after an error has been
detected, check for obvious faults such as ob-
structions before trying to operate the room
again. If the error code appears again, the room
will need to be extended using the crank method
described in the previous section. The crank
method is provided as a means to extend the
room if there is a failure in the automatic system.
If the room must be extended using the crank
method, keep in mind it is likely that it must also
be cranked in to retract. After the outing is com-
pleted and the room is retracted fully, take the
coach to the nearest authorized service center for
inspection.
Error Codes -
The DigiSync slideout system is equipped
with onboard diagnostics capabilities. In the
event of a system failure the green LED on the
left side of the control panel will blink to display
several possible error codes. An error code will
not be displayed unless the “IN” or “OUT” con-
trol panel buttons has been pressed. For example,
the control panel will not display an error code
for low battery voltage unless you are trying to
extend or retract the room when low voltage is
present. Therefore it is a good idea if you have an
error code to write down which error code you
experienced to report it to your authorized ser-
vice center. This information will help the service
technician identify the cause of the problem that
you experienced.
When an error is detected, the green LED on
the left side of the control panel will blink. The
error code can be determined by counting the
number of flashes in between each pause. See the
Error Codes Key below for details. The error
code may be cleared at any time by pressing re-
set, or by allowing the system to ‘time out’ after
60 seconds. Once cleared, the operation can be
tried again. If the error code appears again, see
Manual Mode and or Crank Mode.
Green light will flash
error code, if system malfunctions
Diagnostics
Reset Button
Red light will flash if park
brake not set.
